The setupAstroPi3.sh is for a Raspberry Pi 3b or 3b+ running Ubuntu-Mate in the armhf architecture. Run one of the following scripts using sudo. You could type the following commands into Terminal to accomplish this goal. I would recommend that you try to do this before you run my script.Ĭopy the scripts in this GIT Repo to your SBC and Open a Terminal Window. You might not have the option to setup the login name or computer name in the setup script. If you are running Raspbian or some other SBC, You may need to restart it again to get your wifi network connection started. Note that it may say your name is unavailable at first, but when you enter your login name that may change.Īfter the configuration, your pi will restart. This is difficult to change later, so set it up carefully. You should get a setup window if you are using a Raspberry Pi running Ubuntu-MATE that will allow you to setup your login name and computer name. (Once you have run the script, you can plug in an HDMI monitor or use WIFI at any time) Also be sure to keep it connected to Ethernet, not WIFI, since it will probably lose the connection and not finish halfway through if you use wifi. Note: Until you finish the script, be sure to keep an HDMI display connected while you are setting up the pi, so that the HDMI connection does not go to sleep. Often the SBC will reboot the first time to resize the partition. Also be sure to connect it to the internet with an Ethernet Cord (not WIFI, since it might lose the connection later) Then turn it on. Insert the SD Card into the SBC, connect a mouse, keyboard, and display. Apparently there is an issue where one of the settings is optimized for the Pi 4, but does not work on the Pi 3. If you are installing Ubuntu-MATE on the Pi 3 (not the Pi 4) you will need to edit the /boot/config.txt file before you remove it from your computer. The easiest way to do this is to download the free program Etcher ( )ĭrag and drop the disk image you downloaded into etcher along with the mounted SD card. You will need to flash that img file to the SD card. Probably get an image that is Ubuntu or Raspbian for now. My scripts so far are all based on Ubuntu or Raspbian, so you should If you are using a different SBC, you should find an appropriate image for your system. Download latest version of an image for your SBC.When you are ready, you can follow these steps: Use the script as is or add or remove certain lines before running it by adding or removing comment symbols from the front of the line (#). Hopefully this is much easier to use.īefore running the script, please be sure to do some research and read up on all that it will do to your Raspberry Pi or other SBC. In Fall 2017, I was configuring another PI, went back to my instructions and his guide and followed both. James Taylor wrote a beginners guide which can be accessed here: Then several users on, especially James Taylor ( u2pilotjt ), tested my steps and helped me revise them. I first developed the series of steps by research, trial, and error So that it can be an Astrophotography hub using INDI, KStars, and Ekos. This script is meant to automate the many setup steps involved with configuring a Raspberry Pi 3b, 3b+, 4 or similar single board computer (SBC) running Ubuntu or Raspbian,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |